Team:UGent Belgium/Demonstrate
Demonstration
The goal of or project is to provide a working product that can collect a substantial amount of water. To this end, we performed some experiments to measure the exact quantity of water collected by our 3D-printed shape, coated with polylactic acid (PLA) with biotin and treated with the Ice Nucleating Protein (INP)-streptavidin complex.
We used a mixture of PLA and biotin dissolved in dichloromethane. These were used to either coat water collectors. The coated objects are left to dry overnight in a laminar flow cabinet, allowing the solvent to evaporate.
We considered four biological treatments:
- INP + INP_NC-mSA2: whole cells expressing both full length INP and membrane-bound monomeric streptavidin (mSA2)
- RFP + INP_NC-mSA2 (control): cells expressing membrane-bound mSA2 and a red fluorescent protein
- INP_RC-mSA2: protein extract: INP nucleating domain - mSA2 fusion protein
- mGFPuv2-mSA2 (control): mGFPuv2 - mSA2 fusion protein
The measurements were performed in the controlled humidified chamber. Both the temperature and the humidity were constantly monitored and the latter was actively controlled using on-off control.
In each experiment, the measurements were performed in a controlled humidified chamber. Both the temperature and the humidity was constantly measured and the latter was actively controlled using bang-bang control.
Effect biological treatments on the water collectors
Setup
In this demonstrative experiment, we probed to the effect of the four biological treatments described above.
The dome of four water collector were coated using the PLA-biotin solution. Subsequently each collector was sawn in half in order to have a treatment and associated control for each experimental unit.
Half a water collector.
One half of each collector was treated with a different biological function (i.e. INP + INP_NC-mSA2, RFP + INP_NC-mSA2, INP_RC-mSA2 and mGFPuv2-mSA2). After waiting five minutes, to allow biotin-streptavidin bonds to form, all half-collectors were rinsed thoroughly with a physiological solution. Each halve was placed on a petri dish.
All halves were dried and weighted on an analytical scale. Finally, all petri dished with half a collector were randomly placed in the humidified chamber. They were left under a flow of humid air for one night. Afterwards, all halves were weighted again, as such that the accumulation of water could be determined.
The collectors in the humidified chamber.
Results
The following bar chart shows the difference of in water accumulation in gram of each treatment compared to the half that was used as a control.
Difference in water collection treatment versus control for the four treatments.
The average water amount of water collected by all the experimental units is 3.07 ± 0.38 gram. The difference of the effect of the different treatments (between -0.92 and 0.6 gram difference in water collection of treatment versus control). Unfortunately, it appears that the INP treatments result in a decrease in water collection. As the effect is quite small and we could not perform any replications, it is perhaps safest to conclude that these results do not support any conclusions either way.
