In order to demonstrate our project into real-world conditions, we developed a custom drone able to safely transport our organisms into the chosen areas. We used a 3D printer at La Paillasse to print most of the drone parts ourselves (chassis and feet). Files used to print the drone are available here. The drone was designed in order to safely contain genetically modified using a tube that we also designed and print tubes. The tube, working as an airlock, allowed air sampling without bacterial dissemination in the external environment. (Please note that containment test have only been conducted inside the lab).

The drone is a quadricopter with a 980kv power.It has 4 ESC (motor speed control systems) of 30A and is equipped with a flight control system as well as a distribution circuit.It runs on a 3S battery (5Ah).
It was designed to hold four tubes in the prototype version. In order to open those tubes, the drone is equipped with servomotors able to lift the lid of the tubes. The drone has a 500g payload capacity which is more than needed and a theoretical autonomy of 8 minutes. The extra payload will be used to add other modules to the drone (such as a bleach bottle as explained below).

Even if this drone is just a prototype, it is the first step towards the in field application of our project. Our main objective was to realize a flying drone able to carry the bacteria on-site without dissemination and to sample external air. We did reach this objective : see our flying drone here

There is already a very simple safety mechanism on the drone. If it goes out of the controller’s range, it will lands. However, this will not avoid bacterial dissemination if the drone crashed. This is a second safety mechanism had to be set up. A small bottle of bleach under the drone. In the event of a crash, the bottle would break and spill the bleach, killing any bacteria that might have leaked out of a broken tube.
We proposed some improvements to this prototype:

Containment tubes

Tube design and materials

The bacteria containing tube was one of our challenge. As we are working with living modified organisms, it had to be perfectly closed to avoid any dissemination. Therefore, we designed a tube able to sample external air and expose bacteria to it while remaining perfectly hermetic.

The tube function as an airlock. There is a compartment between the outside environment and the inside of the tube that acts as an interface that do not directly allow the contact of the tube's outside with the tube's inside. At the beginning the tube is half open but air cannot enter. Thanks to little servomotors placed on the drone, tubes can be open allowing air sampling. However, at this step, the bottom of the lid still close the tube preventing bacterial dissemination. Then the tubes completely close and air goes though the interface into the inner part of the tube in which bacteria are. Bacteria are exposed to the pollutant and will start producing luciferase.

We believe that the tube we designed can be a very useful tool for applied synthetic biology and future team will do their best to improve it within the iGEM competition.