Difference between revisions of "Team:Waterloo/InDepthDesign/Crispr"

CRISPR (clustered regularly interspaced short palindromic repeats) is a system used for targeting specific sites of a genome (Cong, 2013; Jinek, 2012). The system is comprised of a Cas protein and an sgRNA which is a short guide RNA, usually about 20nt, which specifies the target site on the genome(Cong, 2013; Jinek, 2012). CRISPR is a very popular tool in genome editing because of its ability to cut specific sites, however it was originally discovered as an adaptive immune system in bacteria (Doudna, 2014). This function of the CRISPR system allows for a targeted knockout of a protein in question.

Our system is a tool that allows the overexpression a protein of interest, which could be used to determine if the protein can slow the [PSI+] response or even cure it. It would also be useful to see if the opposite (a decrease in the expression of a protein of interest) could have similar effects. For instance, overexpressing hsp104 can cure the response by breaking down and refolding misfolded sup35, but knocking down hsp104 expression can also cure the response because the sup35 aggregates need hsp104 in order to replicate. The addition of a CRISPR interference system using dCas9 allows the targeting a protein of interest to cause this knockdown of expression. If we use our system to insert a premature stop codon in front of the CRISPR gene, then it will only be expressed during a [PSI+] state.

Most CRISPR systems use a Cas protein called Cas9 which makes a cut after binding to the DNA. Our system would use dCas9 which is a Cas protein that binds to a site and prevents transcription of that protein. This acts as a more reliable method for knocking out a protein, since cuts can sometimes be repaired effectively through non-homologous end joining.

All sgRNAs must start with a certain sequence of nucleotides called a PAM site, or protospacer adjacent motif. This sequence is recognised by the Cas protein and is thus necessary for it to bind to the sgRNA. The sgRNA recognises the target DNA, thereby acting as an intermediate between the Cas protein and the target. The most common PAM site is NGG where N is any nucleotide.

The target DNA must be carefully chosen in order to avoid accidentally targeting genes important to the host organism, in this case Saccharomyces cerevisiae. CRISPR-Cas systems have been effectively employed in yeast hosts on a number of occasions, indicating that our intentions to do the same have a good chance of success (DiCarlo, 2013; 2015; Smith 2016).

Cong, L., Ran, F.A., Cox, D., Lin, S., Barretto, R., Habib, N., Hsu, P.D., Wu, X., Jiang, W., Marraffini, L.A., & Zhang, F., 2013. Multiplex genome engineering using CRISPR/Cas systems. Science Feb 15;339(6121):819-23.

DiCarlo, J.E. et al., 2013. Genome engineering in Saccharomyces cerevisiae using CRISPR-Cas systems. Nucleic acids research, 41(7), pp.4336–43.

DiCarlo, J.E. et al., 2015. Safeguarding CRISPR-Cas9 gene drives in yeast. Nature Biotechnology, 33(12), pp.1250–1255.

Doudna, J.A. & Charpentier, E., 2014. The new frontier of genome engineering with CRISPR-Cas9. Science, 346(6213), pp.1258096–1258096.

Jinek, M. et al., 2012. A Programmable Dual-RNA–Guided DNA Endonuclease in Adaptive Bacterial Immunity. Science, 337(6096), p.816 LP-821.

Smith, J.D. et al., 2016. Quantitative CRISPR interference screens in yeast identify chemical-genetic interactions and new rules for guide RNA design. Genome Biology, 17(1), p.45.