Team:NCKU Tainan/Hardware
1. Built and characterized a functional and affordable prototype for urine testing in the health care system.
2. Created an instructional video, a manual and bill of materials
3. Implemented Bio-safety to our device
4. Integrated with modeling
5. Cooperated with Tzu Chi University
Measuring fluorescence is an essential part of our project. The fluorescence level indicates the concentration of the reporter protein activated by glucose. However, the commercial devices of measuring fluorescence such as ELISA and fluorescent microscopy are too expensive and not user-friendly for the daily use. Therefore, we, iGEM NCKU, created a cost-friendly device, which is suitable for both public and DIY enthusiasts. This device would bridge the gap between scientific research and public acceptability.
We aimed to develop an innovative device for urine glucose monitoring, but we confronted two problems. First, how would users approach the urine test for a glucose level occasionally? Normally, people do not usually go to a hospital or a pharmacy just for a urine glucose test when they are not diagnosed with diabetes. It is time consuming and a waste of resources to use a single testing without any long term tracing. The second question is how we can bring this device to the public and make people accept it . To be user-friendly, it then became a major consideration for us to make this portable and technology-friendly device available.
The measuring principle of fluorescence is shown below. We use 435 nm blue laser to activate our samples. Then the activated samples will emit 605 nm red light thorough the filter which is designed to block the blue laser when reflected by the samples. We chose cut-off filter at cutting wavelength of 580 nm to eliminate the exciting light. The 605 nm red light then passes through the focusing lens to our detector to maximize the sensitivity of our device.
The structure of our device would contain four parts, sample collection, detection, processing, and transmission.
- Sample Collection
We designed a urine collector connected to our device. It’s a plastic tube fixed in the toilet. With the specific angles, it is feasible to collect urine for both men and women. Next, a stepper motor can pump urine into out device that makes the data is accurate.
The palstic tube is fixed to the to toilet wall with specific angle which allow men and women to use.Another design is the smart panel witch can do the whole process with pressing just one bottom.
- Detection
As mentioned in the previous section, the detector of our device transforms the light intensity to the signal frequency and sends to the processor.
- Processing
The signal then is sent to the processor. We chose Arduino as the processor, because Arduino is an open-source prototyping platform featuring as easy-to-use hardware and software. We coded our Arduino to initialize our detection, to filter our input signal and to measure the result kinetically.
- Transmission
To visualize our data better, we designed an App on smart device (e.g. smart phone, wearables) to show the result. We used Bluetooth to transmit the digital and analog output to the smart devices. Also, the users are empowered to control the device through the smart devices on a user-friendly interface.
- Arduino Mega
- TSL 235R
- LEE Filter 019
- Light sensitive
- Blue laser light 405 nm
- Screen 16*2
- Small breadboard
- Male to Female DuPont Breadboard Jumper Wires
- Power supply
- Holder
[1] Rob H et al., Optical density sensor replacement, Second Semester Report (2009)
