Genetic Circuit Design
Above is a diagram of the larger genetic circuit we envision constructing with the individual parts we have characterized. The first component of the circuit (on the far left) checks for characteristics of the disease during the estrogen-high phase of the menstrual cycle and expresses the first recombinase if it senses them. The second component (in the middle) checks for characteristics of the disease during the progesterone-high phase of the cycle and expresses the second recombinase if it senses them. The final component contains the fluorescent output of the circuit - in healthy cells, the transcriptional stop signal between the promoter and the gene, as well as the gene’s being inverted, suppress the expression of yellow fluorescence. In cells with the disease, however, the first recombinase is expressed and cuts out the terminator sequence, and the second recombinase is expressed and inverts the gene to the correct orientation, allowing expression of eYFP. This biological ‘and’ gate with two temporally distinct checks for the disease greatly increases the specificity for an accurate diagnosis. The following walk-through will detail the mechanics of how the circuit works.
Healthy cells +Estradiol
In a healthy cell during the estrogen-high phase, miRNA 1 is present in low levels and miRNA 2 is present in high levels.
In the first component of the circuit, Repressor 1 is expressed constitutively, and since miRNA 1 is minimally present, this repressor is strongly expressed. Despite estrogen inducing the pERE promoter controlling Recombinase 1, Repressor 1 and miRNA 1 inhibit production of Recombinase 1.
In the second component of the circuit, estrogen induces the production of Repressor 2 under pHybrid. The minCMV promoter controlling Recombinase 2 is constitutive, but Repressor 2 and miRNA 2 are inhibiting production of Recombinase 2.
Since neither of the recombinases are being produced, no modifications to the output component occur, and no yellow fluorescence is expressed.
Healthy cells +Progesterone
In a healthy cell during the progesterone-high phase, miRNA 1 is still present in low levels, and miRNA 2 is still present in high levels.
In the first component of the circuit, the pERE promoter controlling Recombinase 1 is not induced due to the absence of estrogen, so Recombinase 1 is not produced.
In the second component of the circuit, progesterone induces pHybrid, causing Repressor 2 to be expressed and, in conjunction with miRNA 2, suppresses the production of Recombinase 2.
Again, since neither recombinase is produced, the output component is unchanged, and no yellow fluorescence is expressed.